#HOW TO SETUP DBX DRIVERACK 260 FULL#

These features combined with the Wizard setup system and complete DriveWareв„ў GUI control represent a methodical design that is guaranteed to deliver optimal, all-inclusive processing in a completely scalable system. This goal has been achieved by offering two independent channels of processing power with a linkable 28-Band Graphic Equalizer, industry-standard dbx stereo compressor module, feedback eliminator and the 120A Subharmonic Synthesizer on the input, with a six channel output system that includes parametric EQs, PeakStopPlusВ® limiters (to provide protection against speaker blowouts) and alignment delay. The DriveRack 260 was designed with the purpose and vision of providing state-of-the-art signal processing, while utilizing a simple and intuitive user interface. The DriveRack 260 continues the legacy of DriveRack series, which has been created by the company that has been redefining the standard of signal processing for more than 30 years. When pressed and held, the 260 will enter the Wizard section which includes: SYSTEM SETUP, AFS and AUTO EQ WIZARD. Contractors will appreciate its control inputs for wall-panel logic control and the patent-pending Advanced Feedback Suppression (AFSв„ў).

#HOW TO SETUP DBX DRIVERACK 260 FULL#

The 260 provides full bandpass and crossover configurations as well as independent output processing and a full time RTA for live sound applications. Select the System Setup Wizard option by pressing the SELECTwheel. Press and hold the WIZARDbutton for 2 seconds. To run the Setup Wizard, follow these steps: A. Power up 2 Run The Setup Wizard The Setup Wizard will walk you through the configuration process. The 260 capitalizes on the road tested and contractor approved nature of the other products in the DriveRack line. the mixer, then the 260, then your amplifiers or powered speakers. With the introduction of the new 260, the heritage of unrivaled system/loudspeaker control continues. The DriveRack products provide the tools that ensure that the system sounds its very best.

change the internal routing of the signal, link/unlink. There is a reason that Tour Sound Professionals and discriminating Audio Contractors choose dbxВ® DriveRackВ® products for their high-end tours and installs. The Driverack 260 has a CONFIGURATION mode that enables you to go in and. вЂ“вЂ“вЂ“Dynamic processors & Post-production.вЂ“вЂ“вЂ“Recorders, Players & Multitrack Recorders.вЂ“вЂ“вЂ“Digital Converters & Signal Dispatchers.Make sure to match the Panel with the ID dip switch on the side of the ZC-9 controller. Assign a ZC-4 under the Zone Controller section in Utilities. Make sure all DriveRack dynamic processors like GEQ, Compressor, limiters, PEQ, AFS, SubSynth, etc., are disabled.

вЂ“вЂ“вЂ“вЂ“Professional Arrangers & Workstations Question: How do I setup my ZC-9 as a program change with the DriveRack 260 Answer: Walk through of getting your ZC-9 setup with the dbx DriveWare software. Turn amplifier (s) attenuators all of the way down to zero (fully counter clockwise), disable amplifier (s) clip limiters (if used), and disconnect the speaker cables.вЂ“вЂ“вЂ“вЂ“Bass Guitar Gig bags & Flight Cases.

How to setup dbx driverack 260